Description Edit

Ingredients Edit

  • 1 1/2 pounds of shoulder of Veal (cut into 2-inch pieces)
  • 1 1/2 pounds of fresh pig’s knuckles (cracked with a cleaver)
  • 1 large Onion unpeeled
  • 2 large carrot (cut crosswise into 1/8 inch thick rounds)
  • 3 quarts of cold water
  • 4 whole black peppercorns
  • 5 bay leaves
  • 6 tablespoon of salt
  • 7 teaspoon of garlic (finely chopped)

Directions Edit

1. In a cooking pan, combine the Veal, pig`s knuckles, Onion, carrot, and water and bring to a boil over high heat, meanwhile skimming the foam and scum from the surface as they rise to the top.

2. Then add the whole peppercorns and bay leaves, reduce heat to low, an simmer partially covered for about 3 hours, or until the Veal is tender enough to be easily pierced with a fork.

3. With slotted spatula, transfer the Veal and pig`s knuckles to a plate.

4. Strain the cooking stock in the pot trough a fine sieve set over a large bowl and let it rest for about 10 minutes.

5. Then with a large spoon, skim off and discard the entire surface fat. Pour the stock into a small pan and boil it briskly, uncovered, until it has cooked down to 4 cups.

6. When the Veal and pig's knuckles are cool enough to handle, trim off the fat with a small knife and cut the meat away from the bones and cut meat in small shreds.

7. Arrange the carrot slices in concentric circles in the bottom of a 2-quart charlotte or a similar mold at least 3 inches deep.

8. A teaspoon at a time, sprinkle the carrots evenly with the stock, and continue adding the stock by teaspoons until the carrots are half submerged but not floating in the liquid.

9. Carefully place the mold in the refrigerator without dislodging the design and chill for at least 1 hour, or until the stock has firmly jelled. By this time the remaining stock should be cool.

10. Stir in the meat, salt and garlic and taste for seasoning. Then pour the entire mixture into the chilled mold. Refrigerate for at least 4 hours, or until the stock is firm.

11. To remove from its mold, run a knife around the inside edges of the jellied Veal.

12. Dip the bottom of the mold briefly in hot water, then invert a flat serving dish on top. Holding the mold and plate firmly together, turn them over. The jellied Veal should slide out easily.

Community content is available under CC-BY-SA unless otherwise noted.